Same systemname in second, third, or multiple PBX with v12r2

Note: The information below only applies to PBX systems with v12r2, in v13r1 and higher this limitation no longer exists.

Try to avoid having the same systemname in different PBX's. If you can't avoid it and the Customer has the same systemname in more than one PBX and there is no replication between theses PBX's like in a master-slave scenario or if it is a separate master with the same systemname:

The customer is NOT able to setup a Push Object like described in this wiki in the second system or even the setup will result in a disconnect of the Push object in the first system.

In this case there are two options to solve this problem without that the customer has to change the systemname.

Option 1:

innovaphone has to add the systemname/domain manual in the Push Admin and create a secret password and send this to the customer.

The Customer has to create a Push Object different as described in the wiki. In all systems where they create the Push Object, they must use the by innovaphone created password and leave the emailaddress field empty!

For this scenario you have to create a Support Ticket

Option 2:

Option2 is only possible if the PBX password of the different systems is exactly the same.

The customer can copy the Push object from the config of the first working Push object into the config of the second system.

This can be done by download both configs. Copy & paste the Pushobject to the config of the system without Push Object.

Upload the config. Be aware a system reboot is necessary.